We demonstrate the logistic feasibility and scientific potential of Distributed Acoustic Sensing (DAS) in alpine volcano-glacial environments that are subject to a broad range of natural hazards. Our work considers the Mount Meager massif, an active volcanic complex in British Columbia, estimated to have the largest geothermal potential in Canada, and home of Canada’s largest recorded landslide in 2010. From September to October 2019, we acquired continuous strain data, using a 3 km long fiber-optic cable, deployed on a ridge of Mount Meager and on the uppermost part of a glacier above 2000 m altitude. The data analysis detected a broad range of unexpectedly intense, low-magnitude, local seismicity. The most prominent events include long-lasting, intermediate-frequency (0.01 - 1 Hz) tremor, and high-frequency (5 - 45 Hz) earthquakes that form distinct spatial clusters and often repeat with nearly identical waveforms. We conservatively estimate that the number of detectable high-frequency events varied between several tens and nearly 400 per day. We also develop a beamforming algorithm that uses the signal-to-noise ratio (SNR) of individual channels, and implicitly takes the direction-dependent sensitivity of DAS into account. Both the tremor and the high-frequency earthquakes are most likely related to fluid movement within Mount Meager’s geothermal reservoir. Our work illustrates that DAS carries the potential to reveal previously undiscovered seismicity in challenging environments, where comparably dense arrays of conventional seismometers are difficult to install. We hope that the logistics and deployment details provided here may serve as a starting point for future DAS experiments.

Seismologists working with fiber-optic sensing, commonly referred to as Distributed Acoustic Sensing (DAS), have yet to find an established way of automatically detecting signals of interest within its recordings. We propose a new research perspective within the field by examining the output of a DAS array as an image and processing the image to find signals of interest. In this manuscript, we show an example of such a method, where we automatically detect seismic events of interest within two different DAS datasets, finding, respectively 99 % and 96 % of the local earthquakes previously identified within the data by manual analysis. The method is based on simple image processing and computer vision techniques, which clean the image, and, ideally, leave nothing but the signal of interest. These simple image processing steps yield promising results, indicating that computer vision and image processing might have an immediate impact in geophysical applications of fiber-optic sensing.