The instrument package SEIS (Seismic Experiment for Internal Structure) with the three very broadband and three short-period seismic sensors is installed on the surface on Mars as part of NASA’s InSight Discovery mission. When compared to terrestrial installations, SEIS is deployed in a very harsh wind and temperature environment that leads to inevitable degradation of the quality of the recorded data. One ubiquitous artifact in the raw data is an abundance of transient one-sided pulses often accompanied by high-frequency spikes. These pulses, which we term “glitches”, can be modeled as the response of the instrument to a step in acceleration, while the spikes can be modeled as the response to a simultaneous step in displacement. We attribute the glitches primarily to SEIS-internal stress relaxations caused by the large temperature variations to which the instrument is exposed during a Martian day. Only a small fraction of glitches correspond to a motion of the SEIS package as a whole caused by minuscule tilts of either the instrument or the ground. In this study, we focus on the analysis of the glitch+spike phenomenon and present how these signals can be automatically detected and removed from SEIS’ raw data. As glitches affect many standard seismological analysis methods such as receiver functions, spectral decomposition and source inversions, we anticipate that studies of the Martian seismicity as well as studies of Mars’ internal structure should benefit from deglitched seismic data.

The InSight mission (Interior Exploration using Seismic Investigations, Geodesy and Heat Transport) has been collecting high-quality seismic data from Mars since February 2019, shortly after its landing. The Marsquake Service (MQS) is the team responsible for the prompt review of all seismic data recorded by the InSight’s seismometer (SEIS), marsquake event detection, and curating seismicity catalogues. Until sol 1011 (end of September 2021), MQS have identified 951 marsquakes that we interpret to occur at regional and teleseismic distances, and 1062 very short duration events that are most likely generated by local thermal stresses nearby the SEIS package. Here, we summarize the seismic data collected until sol 1011, version 9 of the InSight seismicity catalogue. We focus on the significant seismicity that occurred after sol 478, the end date of version 3, the last catalogue described in a dedicated paper. In this new period, almost a full Martian year of new data has been collected, allowing us to observe seasonal variations in seismicity that are largely driven by strong changes in atmospheric noise that couples into the seismic signal. Further, the largest, closest and most distant events have been identified, and the number of fully located events has increased from 3 to 7. In addition to the new seismicity, we document improvements in the catalogue that include the adoption of InSight-calibrated Martian models and magnitude scales, the inclusion of additional seismic body-wave phases, and first focal mechanism solutions for three of the regional marsquakes at distances ~30 degrees.

Seismic noise recorded at the surface of Mars has been monitored since February 2019, using the seismometers of the InSight lander. The noise on Mars is 500 times lower than on Earth at night and it increases during the day. We analyze its polarization as a function of time and frequency in the band 0.03-1Hz. We use the degree of polarization to extract signals with stable polarization whatever their amplitude. We detect polarized signals at all frequencies and all times. Glitches correspond to linear polarized signals which are more abundant during the night. For signals with elliptical polarization, the ellipse is in the horizontal plane with clockwise and anti-clockwise motion at low frequency (LF). At high frequency (HF), the ellipse is in the vertical plane and the major axis is tilted with respect to the vertical. Whereas polarization azimuths are different in the two frequency bands, they are both varying as a function of local time and season. They are also correlated with wind direction, particularly during the day. We investigate possible aseismic and seismic origin of the polarized signals. Lander or tether noise are discarded. Pressure fluctuation transported by environmmental wind may explain part of the HF polarization but not the tilt of the ellipse. This tilt can be obtained if the source is an acoustic emission in some particular case. Finally, in the evening when the wind is low, the measured polarized signals seems to correspond to a diffuse seismic wavefield that would be the Mars microseismic noise.

We present inversions for the structure of Mars using the first Martian seismic record collected by the InSight lander. We identified and used arrival times of direct, multiples, and depth phases of body waves, for seventeen marsquakes to constrain the quake locations and the one-dimensional average interior structure of Mars. We found the marsquake hypocenters to be shallower than 40 km depth, most of them being located in the Cerberus Fossae graben system, which could be a source of marsquakes. Our results show a significant velocity jump between the upper and the lower part of the crust, interpreted as the transition between intrusive and extrusive rocks. The lower crust makes up a significant fraction of the crust, with seismic velocities compatible with those of mafic to ultramafic rocks. Additional constraints on the crustal thickness from previous seismic analyses, combined with modeling relying on gravity and topography measurements, yield constraints on the present-day thermochemical state of Mars and on its long-term history. Our most constrained inversion results indicate a present-day surface heat flux of 22±1 mW/m2, a relatively hot mantle (potential temperature: 1740±90 K) and a thick lithosphere (540±120 km), associated with a lithospheric thermal gradient of 1.9±0.3 K/km. These results are compatible with recent seismic studies using a reduced data set and different inversions approaches, confirming that Mars’ mantle was initially relatively cold (1780±50 K) compared to its present-day state, and that its crust contains 10-12 times more heat-producing elements than the primitive mantle.

Seismic observations involve signals that can be easily masked by noise injection. For InSight, NASA's lander on Mars, the atmosphere is a significant noise contributor for two thirds of a Martian day, and while the noise is below that seen at even the quietest sites on Earth, the amplitude of seismic signals on Mars is also considerably lower requiring an understanding and quantification of environmental injection at unprecedented levels. Mars' ground and atmosphere provide a continuous coupled seismic system, and although atmospheric functions are of distinct origins, the superposition of these noise contributions is poorly understood, making separation a challenging task. We present a novel method for partitioning the observed signal into seismic and environmental contributions. Pressure and wind fluctuations are shown to exhibit temporal cross-frequency coupling across multiple bands, injecting noise that is neither random nor coherent. We investigate this through comodulation, quantifying the signal synchrony in seismic motion, wind and pressure. By working in the time-frequency domain, we discriminate the origins of underlying processes and provide the site's environmental sensitivity. Our method aims to create a virtual vault at InSight, shielding the seismometers with effective post-processing in lieu of a physical vault. This allows us to describe the environmental and seismic signals over a sequence of sols, to quantify the wind and pressure injection, and estimate the seismic content of possible Marsquakes with a signal-to-noise ratio that can be quantified in terms of environmental independence. Finally, we exploit the temporal energy correlations for source attribution of our observations.

The SEIS seismometer deployed at the surface of Mars in the framework of the NASA-InSight mission has been continuously recording the ground motion at Elysium Planitia for more than one martian year. In this work, we investigate the seasonal variation of the near surface properties using both background vibrations and a particular class of high-frequency seismic events. We present measurements of relative velocity changes over one martian year and show that they can be modeled by a thermoelastic response of the Martian regolith. Several families of high-frequency seismic multiplets have been observed at various periods of the martian year. These events exhibit repeatable waveforms with an emergent character and a coda that is likely composed of scattered waves. Taking advantage of these properties, we use coda waves interferometry to measure relative travel-time changes as a function of the date of occurrence of the quakes. While in some families a stretching of the coda waveform is clearly observed, in other families we observe either no variation or a clear contraction of the waveform. Measurements of velocity changes from the analysis of background vibrations above 5Hz are consistent with the results from coda wave interferometry. We identify a frequency band structure in the power spectral density, that can be tracked over hundreds of days. This band structure is the equivalent in the frequency domain of an autocorrelogram and can be efficiently used to measure relative travel-time changes as a function of frequency. The observed velocity changes can be adequately modeled by the thermoelastic response of the regolith to the time-dependent incident solar flux at the seasonal scale. In particular, the model captures the time delay between the surface temperature variations and the velocity changes in the sub-surface. Our observations could serve as a basis for a joint inversion of the seismic and thermal properties in the first meters below InSIght.

The SEIS seismometer of the InSight mission was deployed on the ground of Elysium Planitia, on 19 December 2018. Interferometry techniques can be used to extract information on the internal structure from the autocorrelation of seismic ambient noise and coda of seismic events. In a single-station configuration, the zero-offset global reflection of the ground vertically below the seismometer can be approximated by the stacked ZZ autocorrelation function (ACF) for P-waves and the stacked EE and NN ACFs for S-waves, assuming a horizontally layered medium and homogeneously distributed and mutually uncorrelated noise sources. We analyze continuous records from the very broadband seismometer (SEIS-VBB), and correct for potential environmental disturbances through systematic preprocessing. For each Sol (martian day), we computed the correlations functions in 24 windows of one martian hour in order to obtain a total correlation tensor for various Mars local times. In addition, a similar algorithm is applied to the Marsquake waveforms in different frequency bands. Both stability analysis and inter-comparison between background noise and seismic event results suggest that the background seismic noise at the landing site is reliably observed only around 2.4 Hz, where an unknown mechanism is amplifying the ground shaking, and only during early night hours, when the noise induced by atmospheric disturbances is minimum. Seismic energy arrivals are consistently observed across the various data-sets. Some of these arrivals present multiples. These observations are discussed in terms of Mars’ crustal structure.

NASA’s InSight mission records several high-frequency (>0.5 Hz) dispersive seismic signals. These signals are due to the acoustic-to-seismic coupling, where the infrasound is generated by meteorite entry and impacts. This dispersion property is due to infrasound propagating in a structured atmosphere, and we refer to this infrasound as guided infrasound. We propose to model the propagation of guided infrasound and the seismic coupling to the ground analytically; we use a 1D layered atmosphere on a three-layer solid subsurface medium. The synthetic ground movements fit the observed dispersive seismic signals well. We also examine and validate the previously-published subsurface models derived from the InSight ambient seismic vibration data.