loading page

A study of the Rain Impact Model (RIM) under different wind speed conditions
  • +2
  • Maria Marta Jacob,
  • Linwood Jones,
  • Kyla Drushka,
  • William Asher,
  • Marcelo Scavuzzo
Maria Marta Jacob

Corresponding Author:[email protected]

Author Profile
Linwood Jones
University of Central Florida College of Engineering and Computer Science
Author Profile
Kyla Drushka
University of Washington Applied Physics Laboratory
Author Profile
William Asher
University of Washington Applied Physics Laboratory
Author Profile
Marcelo Scavuzzo
Universidad Nacional de Cordoba Facultad de Matematica Astronomia y Fisica
Author Profile


When rain falls over the ocean, it produces a vertical salinity profile that is fresher at the surface. This fresh water will be mixed downward by turbulent diffusion through gravity waves and the wind stress, which dissipates over a few hours until the upper layer (1-5 m depth) becomes well mixed. Therefore, there will be a transient bias between the bulk salinity, measured by in-situ instruments, and the satellite-measured SSS (representative of the first cm of the ocean depth). Based on observations of Aquarius (AQ) SSS under rain conditions, a rain impact model (RIM) was developed to estimate the change in SSS due to the accumulation of precipitation previous to the time of the satellite observation. RIM uses ocean surface salinities, from the HYCOM (Hybrid Coordinate Ocean Model) and the NOAA global rainfall product CMORPH, to model transient changes in the near-surface salinity profile. Also, the RIM analysis has been applied to SMOS (Soil Moisture and Ocean Salinity) and SMAP (Soil Moisture Active Passive), with similar results observed. The original version of RIM assumes a constant vertical diffusivity and neglects the effects of wind and wave mixing. However, it has been shown that the persistence of rain-induced salinity gradients depends on wind speed, with freshening due to rain during weak winds (less than 2 m/s) persisting for 8 hours or more. Moreover, the mechanical mixing of the ocean caused by wind and waves rapidly reduces the salinity stratification caused by rain. Also, previous results using RIM, in the presence of moderate/high wind speeds, show that the model overestimates the effect of rain on the SSS, which suggests that for RIM to accurately model the near-surface salinity stratification, the effect of wind needs to be included in the model. To address this issue, this paper will focus on an improved RIM-2 that parameterizes the effects of wind on the vertical diffusivity (Kz). Results will be presented that compare RIM and RIM-2 calculations at different depths for several Kz parametrizations. Also, comparisons, between RIM-2 at depths of several meters with measurements from in-situ salinity instruments, will be presented.